Hardware Installation
Rev 2.6
20
Mellanox Technologies
5. When the adapter is properly seated, the port connectors are aligned with the slot opening,
and the adapter faceplate is visible against the system chassis.
6. Secure the adapter with the adapter clips or screws.
7. Close the system case.
3.7
Cables and Modules
To obtain the list of supported cables for your adapter, please refer to:
http://www.mellanox.com/products/interconnect/cables-configurator.php
3.7.1 Cable Installation
1. All cables can be inserted or removed with the unit powered on.
2. To insert a cable, press the connector into the port receptacle until the connector is firmly
seated.
a. Support the weight of the cable before connecting the cable to the adapter card. Do this by using a cable
holder or tying the cable to the rack.
b. Determine the correct orientation of the connector to the adapter card before inserting the connector. Do not
try and insert the connector upside down. This may damage the adapter card.
c. Insert the connector into the adapter card. Be careful to insert the connector straight into the cage. Do not
apply any torque, up or down, to the connector cage in the adapter card.
d. Make sure that the connector locks in place.
When installing cables make sure that the latches engage.
Always install and remove cables by pushing or pulling the cable and connector in a
straight line with the card.
