Hardware Installation
Rev 2.6
17
Mellanox Technologies
3
Hardware Installation
3.1
System Requirements
3.1.1 Hardware
A system with a PCI Expressx16 slot is required for installing the card.
3.2
Operating Systems/Distributions
Please refer to
Section 1.3, “Operating Systems/Distributions,” on page 15
.
3.2.1 Software Stacks
Mellanox OpenFabric software package MLNX_OFED for Linux, WinOF-2 for Windows and
VMware. See
Chapter 4,“Driver Installation” on page 24.
3.3
Safety Precautions
1. Remove any metallic objects from your hands and wrists.
2. Make sure to use only insulated tools.
3. Verify that the system is powered off and is unplugged.
4. It is strongly recommended to use an ESD strap or other antistatic devices.
3.4
Pre-installation Checklist
1. Verify that your system meets the hardware and software requirements stated above.
2. Shut down your system if active.
3. After shutting down the system, turn off power and unplug the cord.
4. Remove the card from its package.
5. Please note that the card must be placed on an antistatic surface.
6. Check the card for visible signs of damage. Do not attempt to install the card if damaged.
3.5
Bracket Installation Instructions
The adapter card is usually shipped with a tall bracket installed. If this form factor is suitable for
your requirements, you can skip the remainder of this section and move to Section 3.6, “Adapter
The adapter is being installed in a system that operates with voltages that can be lethal.
Before opening the case of the system, observe the following precautions to avoid
injury and prevent damage to system components.
