Melec ADB-2F50B, Инструкция по эксплуатации

Страница: 21 / 43

ADB-2F50B
Instructions Manual
６．Connection
６－１．Overview of Connection Configuration
DC Power Supply
DC+24V
0V(GND)
User ADB-2F50B
Controller
Twisted J3 1 2 3 4 J2 1 2
pair wire J1
CWP CW+
CWP CW-
CCWP CCW+
CCWP CCW-
+COM M.F+
M.F M.F-
P.O P.O
R.GND R.GND
O.H.A O.H.A
R.GND R.GND
●Connect only one motor to one driver.
●Do not power ON/OFF by the relay etc. in the output side of the DC power supply.
●Use twisted pair wire for the CW/CCW input signal line.
●Provide shielding for the signal line where considerable noise is generated.
●Use the wire material of the characteristic that is difficult to burn.
●Provide shielding for the motor line if it generates significant noise.
●For the driver's power supply, use a DC power supply with reinforced insulation
on its primary and secondary sides.
〔Example configuration〕
The metallic enclosure and shielded wires work to shield noise.
Metal Enclosure Metal Enclosure
Metal Enclosure
User
Controller
ADB-2F50B
5
6
7
8
9
10
1
2
3
4
MOTOR
Shield Shield
Grounding Grounding Grounding
MOTOR
A A B B
DC+ DC-
-21-