File Name:
MEITRACK MVT800 User Guide
Creator:
Meitrack
Project:
MVT800
Creation Date:
Update Date:
2013-03-03
2014-02-26
Sub Project:
User Guide
Page:
17 of 25
Revision:
V1.8
Confidential:
External Documentation
2. Calibrate Manually: GPS Speed will be calibrated by setting manually.
1) Send SMS/GPRS Command B23 to enter the status of calibration. The buzzer will make a long sound and the
green light on.
SMS Command:
0000,B23,Status
Description:
Status=1, entering calibration; the SMS Command is: 0000,B23,1
Status=2, exit calibration
Get:
0000,B23,OK
2) After the Vehicle drives at the speed of 40km/h, press SOS for 2s, MVT800 starts to count the numbers of pulse;
after calibrating successfully, the buzzer will make 2 short sounds and 2 long sounds, and the green light recover
to the normal status.
3) The calibrate value will be saved automatically after successfully, it will no long to count by GPS speed.
4) Without press SOS after on the status of calibration, the calibration will exit automatically.
6.7.2 RF Match Wireless Remote Control and Vehicle (Optional)
If the wireless remote control doesn’t match with MVT800, please match the code manually. To get the status of
the matching, please install buzzer alarm when matching the code.
There are 2 methods:
1. Match by ACC
Note: If connected Input 4 with ACC, please match follow the steps as below:
1) Turn ACC OFF to ACC ON for 8 times, on the 8
th
times stay at ACC ON.
2) Wait for 3 seconds, the buzzer will make 2 short sounds and a long sound entering the matching status, and
the green light of the wireless remote control on at the same time.
3) In the status of matching, please press any key of the wireless remote control which is under code matching in
20 seconds. The buzzer will make two sounds to prompt matching successfully.
If continue to matching a second wireless remote control, please press any key within this 20 seconds. The buzzer
will make two sounds to prompt matching successfully.
4) Only matching for one wireless remote control, if no any operation when successfully matching code, it will exit
automatically after 20 seconds.
Note:
The times of turn ACC ON to OFF will be cleaned if the time internal beyond 3s in one turns.
Please complete code match within 20 seconds, or it will exit automatically.
If pressing for a second time on the same wireless remote control, it will successfully match code and exit
the matching mode.
2. Match by SMS Command:
1) SMS Command: 0000,B24,Status
Description: Status=1, entering matching; the SMS command is 0000,B24,1
Status=0, exit matching
Get: 0000,B24,OK
2) After enter into the status of matching, please refer to the above steps.
Copyright © 2014 Meitrack Group All rights reserved.
17
All manuals and user guides at all-guides.com
