File:ert100-lcd-ir(eu).doc | November 10, 2011 | Rev. 2
Meitav-tec Ltd. (Contel group), 6 Sapir street, New Industrial Zone P.O.B 5221 Rishon-Lezion, 75150, Israel
Tel: +972-3-9626462, Fax: +972-3-9626620, Web: www.meitavtec.com, E-mail: [email protected]
2. Remote control unit
2.1 General
•
Each time you press the ON/SEND button all the information on the
display is sent to the panel.
•
Point the remote control towards the panel to send the information.
•
The red led will blink to indicate that the information was recieved.
•
In order to turn the unit off, simply press the OFF button. All the information
on the remote control display will be sent to the panel and the unit will turn
off.
•
If no button is pressed for 10 seconds the display will return to normal
display mode.
•
The Timer program will repeat itself until cancellation (timer OFF)
2.2 Operating
Manual
2.2.1 On/Send
Activate the air conditioner and/or updating information.
2.2.2 Mode
•
Press the MODE button to switch between: COOL, HEAT, AUTO CHANGE and FAN ONLY.
•
Press the ON/SEND button to send information to the thermostat.
2.2.3 Fan
•
Press the FAN button to switch between: High speed, Medium speed, Low speed and AUTO FAN (A).
•
Press the ON/SEND button to send information to the thermostat.
2.2.4 Set
Temperature
•
Adjust the set temperature using the “+” and “-“ buttons.
•
Press the ON/SEND button to send the information to the thermostat.
2.2.5
Real time clock and day
IMPORTANT: If no button is pressed for 10 seconds the display will return to normal display mode.
•
Press the SELECT button - CLOCK SET will flash.
•
Adjust the hours using the “+” and “-“ buttons.
•
Press the SELECT button again - the minutes will flash.
•
Adjust the minutes using the “+” and “-“ buttons.
•
Press the SELECT button again to finish.
•
Press the ON/SEND button to send the information to the thermostat.
