2. Slide the 2 slots of the splitting
wedge support foot into the 2 clamp-
ing screws while holding the splitting
wedge support foot between the 2
plate surfaces. Tilting the table can
make this task easier.
3. Tighten the clamping screws.
Adjusting the splitting wedge
Make sure that there is enough space
between the cutting disc and the contact
guard. The rotating cutting disc could
touch the contact guard during use.
Readjust the left/right position of the
splitting wedge if the rotating cutting disc
touches the inside of the blade guard.
- The splitting wedge must be aligned
with the cutting disc (2). Check the
alignment with a gauge.
- If necessary, loosen the screws and
adjust the position of the splitting
wedge.
Assembling the stop
The stop can be adjusted to the desired
position using the scale on the support
table.
- Attach the parallel stop (10) to the
support table by tightening the lock-
ing screw (9) on both sides.
- Make sure that the stop is parallel to
the direction of the blade.
Angle cuts
Use the same procedure as for a straight
cut, but use the angle stop (11) to cut
the tiles at 45°. Make sure the tile is held
firmly in the guide before making the cut.
Mounting the cutting disc
1. Remove the water tank (7) by tilt-
ing the power tool upwards slightly.
Loosen two screws on the left and
right of the plastic cover (14). Note
that the fixing screws are firmly
attached to the plastic cover (14) and
must not be completely removed.
Remove cutting disc.
2. Remove the outer flange and spindle
nut.
3. Slide the cutting disc (2) over the
spindle. The arrow on the cutting disc
must point in the same direction of
rotation as the arrow on the metal
plate near the spindle and the plastic
cover (14). Slide the flange over the
cutting disc. Screw the spindle nut
onto the spindle. Hold the spindle in
this position with the 8 mm spanner
(supplied) and tighten the spindle nut
with the 19 mm spanner (supplied).
4. Slide the plastic cover (14) over the
cutting disc and tighten the screws.
Selecting and replacing the diamond
cutting disc
CAUTION! Switch the control to
the “Off” position. Disconnect the
mains plug!
Remove the water tank (7) by tilting the
power tool upwards slightly. Then loosen
the screws of the plastic cover (14) and
remove it (Fig. 1 and 2).
Loosen the outer spindle nut by turning
it anticlockwise. Hold the spindle in this
position with the 8 mm spanner (sup-
plied) and unscrew the spindle nut with
the 19 mm spanner (supplied). (Fig. 3).
Remove the outer flange and spindle nut.
50
5461060-Fliesenschneider-man.indd 50
5461060-Fliesenschneider-man.indd 50
12.05.22 10:13
12.05.22 10:13
