Meinberg IMS-TCR, Руководство по установке

Страница: 19 / 26

7.2 Installation of Hot-Pluggable IMS Modules.
If the system is supplied with an antenna and antenna cable, it is advisable to first mount the antenna in
a suitable location (refer to the chapter "Mounting the Antenna" in your IMS system manual) and to lay the
antenna cable.
Please use a Torx screwdriver (T8 x 60) to remove and install IMS modules.
1. Follow the safety instructions at the beginning
of this manual!
2. Remove the two marked Torx screws from the
module holder plate or the cover plate of
the empty slot.
3. Please note when removing modules:
The module must be pulled carefully out of the
guide rail. Note that the module will be
securely seated in the connector block inside
the chassis—a certain amount of force must
be applied to release the module. Once the
module has been detached from the connector
block in the system backplane, the module can
be easily pulled out.
4. Please note when installing modules:
Ensure that the module is correctly inserted into the two guide rails of the system chassis. Failure
to do so may result in damage to the module and chassis. Ensure that the module is securely seated
in the connector block inside the chassis before you fasten the two screws.
5. The installed module is now ready for use.
Locations of fixture screws in a 1RU IMS system
16 Date: December 17, 2021 IMS-TCR180