7
1.
The device allows you to record
ONLY
in FOLDER 1. To change to FOLDER 1, press
+
, when
the LCD display shows FOLDER 1, you are in FOLDER 1 mode. (
○
1
)
2.
The device allows you to record into the internal flash me mory or into an installed SD ca rd me mo ry (
○
2
). The
PDR-1will change to the SD card me mory automatica lly when SD card is installed. Or you can press
+
to interchange between the me mory of the internal flash me mo ry (F) and the SD card (C).
3.
Press
+
or
+
to select the group number in the range fro m range 1 to 9. (
○
3
)
4.
Press
or
to select the recording track in the range fro m 01 to 99 to record (
○
4
). You may
select any of a blank trac k nu mber you want to record to, then press
button to record; Or just press
button directly, the device will select a blank t rack follows the last recorded track nu mber to record (for
e xa mple , if the last recorded track nu mber is 05, the automatica lly selected track nu mber will be 06).
5.
Press
button to start recording, the
Recording indicator LED
will light up still, the LCD display will
show “
●
”, and the time clock will start running (
○
5
), wh ich means that the recording is in progress. Press
to pause record during recording, the
Recording indicator LED
will start flash, press the same button
again to continue recording. Press
button to finish recording.
6.
The volume indicator will show on the LCD during record ing (
○
6
), you can adjust input volume by the
Volume
controller of Audio-in
(
○
8
or
○
9
). Please do not set to the highest volume level on recording, otherwise, the
recording sound quality will be distorted.
7.
When you finish recording, the recording format and sample rate of th is track will show up on the LCD. (
○
7
)
8.
For long time record ing, you can switch
Key hold switch
(
○
14
)
to ON position to hold (stop running) the key
control. And switch to OFF position to re lease key control.
Recor d fr om microphones
1.
The PDR-1 is equipped with two built-in microphones (omni directional condenser type). You may adjust
high/low sensitivity level of built-in mic rophones for recording fro m the
Built-in microphone sensitivity selector
(
○
13
). The high sensitivity level of built-in microphone is at -45d B(at 1KHz), while the low sensitivity leve l is at
-35dB(at 1KHz). You may a lso adjust the
Volume controller of Audio-in
to make slight volume adjustment.
(
○
8
or
○
9
)
2.
There are two e xtension
Audio-in jack s
of PDR-1 (
○
10
&
○
11
). They allow you to plug two extension
microphones into the jacks for record ing, please select to “M” position of the A
udio-in selector
(
○
12
). The
two A
udio-in jack s
both provide DC 1.5V powe r; you may use either condenser mic rophones or dynamic
