Megasat Caravanman 85 Professional, Руководство пользователя

Страница: 26 / 41

ENGLISH ENGLISH
10
11
Installation Preparing for the installation
This section provides a general explanation on how to install the antenna properly.
The steps in the installation and setup process are as follows:
Unpacking the unit 10
Preparing for the installation 11
Selecting the location 12
Equipment and cable installation 13
Setting the LNB Skew Angle 14
Warning : Things to consider when installing the antenna
• Turn off the power when attaching or detaching the antenna.
• Make sure that the attached satellite is fixed on the flat surface.
• When attaching, ensure that all the products are adhered properly.
• nsure that all the cables are connected properly.
1. Verification of the Vessel’s Power Supply.
• Confirm that the vessel’s power supply is 12V DC 5A.
NOTE:
Look for a sufficiently charged battery when you align the antenna. Loading
procedures can result in abnormal alignment. Be guaranteed for operation over the
230V/12V board voltage or power supply unit must be an output of 12V/5A.
2. Verification of the set-top-box and IDU’s attachment and the electricity supply
• Attach Satellite Receiver and IDU in the interior of the vessel or the trunk.
• Connect the power of Satellite Receiver and IDU.
• Once the power of Satellite Receiver and IDU is verified, it confirms that both Satellite
Receiver and IDU are working normally.
3. Handling of the fastening and installation.
• Attach the satellite on the flat surface area of the vessel’s roof.
• Connect each end of the Coaxial antenna cable to the satellite’s terminal and the IDU.
• Connect the IDU and the Satellite Receiver box together through the coaxial cable.
• Make sure that the satellite is working normally, once the power is supplied.
Table 2-1 Parts included
• Antenna Unit
• 85cm Dish
• IDU(In Door Unit)
• Main Cable ( Attached Antenna Pedestal ) (10m)
• Coaxial Cable (10m)
• Coaxial Cable (1m)
• Power Cable (1m)
• Gluing set (optional)
Unpacking the unit
1. Open box and remove packing material.
The following items are included in the packaging of the antenna.
2. Lift dome out of box vertically. Then lift unit out of box vertically. Do not turn box and
“roll” out, or turn upside down to remove.
Install Tools and Materials
The antenna system is designed for simple installation and setup. However, the following
list of equipment or items should be available during installation of the antenna:
• Electric drill and drill bits
• Socket wrench
• Silicon sealant
• Fastener suitable for specific application
Lift Unit straight up out of the
carton!
Figure 2-1 Unpacking the unit
!