Installation instruction CMAX-O-CPUSEWV53
Page 1
M0149ABB_Installation_CMAX-O-CPUSEWV53-Antenna
Installation Of CMAX-O-CPUSEWV53 Antenna
Note: Please read the complete description before starting the installation. Make sure that
connectors are properly sealed against water if no cables are connected to them after
installation.
Installation without the Ceiling Mount kit:
Installation Steps
1) Cut a hole in the ceiling tile with the diameter shown above.
2) Remove the retaining nut from the back of the antenna (labeled tight part for connector
in the diagram above).
3) Feed the pigtail of the antenna through the hole in the ceiling tile.
4) Re-install the retaining nut so that it is snug against the ceiling tile.
18mm/0.7in
