P. IGNITION CONTROL DOOR LOCK/UNLOCK.
(See Alarm Feature
II – 2
Programming).
If the vehicles door locks have been interfaced to the security system, the system will automatically lock
the vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is
turned “OFF”
Q. TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press and hold
button on the transmitter for two seconds to remote control the
trunk release or other electric devices.
R. CHANNEL 4 TIMER CONTROL OUTPUT
(See Alarm Feature
III – 4
Programming.)
Press the transmitter and
buttons at the same time to active Channel 4 function. Channel 4 is
user-programmable timer output. You may program the built-in timer to send a ground signal for any time
duration from 1 second to 120 seconds. For instance, this timer output may be used to turn on the headlight,
power window or sunroof. (Factory defaults setting at momentary output.)
S. DRIVER PAGING / LOSE & FOUND
(For two-way
transceiver
operation only)
It is useful the event that someone wants to page the driver of the parked vehicle or
someone cannot find his LCD remote control transceiver.
Under the ignition switch “off” condition, press and hold the valet switch for 2 seconds
to page the driver, one chirp sound shall be emitted from the vehicle and the paging
melody sound continues sounding from you Remote LCD transceiver and “
”
indication flashes on the LCD screen.
T. OUT OF RANGE INDICATION:
(See Alarm Feature
II – 5
Programming.)
If this feature is selected, the system will automatically check the range every 30 minutes after armed.
1. If user is within the range, the icon will display on the LCD screen.
2. If user is out of range, it has five short “bi” sounds and the icon will disappear on the LCD screen.
Note:
Programming “out of range indication” will decrease the life expectancy of battery
U. POWER ON MEMONRY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state if the power
is lost and then reconnected.
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE:
1. Press
button twice on the transmitter.
2. The parking light will activate to indicate the remote start received the signal. (A melody sounding from
your Remote LCD transceiver and “
” icon will flashes on the LCD screen to
confirm the remote start was activated.)
3. The engine will start approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking light will turn on again
and climate controls will activate and adjust the vehicles interior temperature to your
preset setting. (While the vehicle is running, the “
” icon on the LCD screen will
flash and it will indicate count down timer based on the 5, 10, 20 or 30 minute run
time set up by your installation center.)
5. The vehicle will run for 5 to 30 minute cycle and automatically shut down. (When the
unit shuts off the count down timer will turn off and the transmitter will play a melody.)
Note:
The Remote Start Unit will not start the vehicle if any one of the following
conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”
Activate Remote
Start
Engine Running
SAFE START (Child safety mode)
(See Start Feature
I – 5
Programming.)
Factory defaults setting to press the
button twice on the transmitter to start the vehicle. Programming this
feature to eliminate an accidental remote start, when kids enter this transmitter, it enquires:
The user presses the transmitter
and
buttons at the same time to start the vehicle.
B. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:
To operate the vehicle while engine running on the remote start.
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
7
