3
SAFETY INSTRUCTIONS (cont.)
10.
ALWAYS WEAR EYE PROTECTION.
Any power tool can throw debris into
the
eyes during operations, which could cause severe and permanent eye damage.
Everyday eyeglasses are
NOT
safety glasses.
11.
ALWAYS WEAR HEARING PROTECTION.
Plain cotton is not an acceptable protective device. Hearing
equipment should comply with ANSI S3.19 Standards.
12.
ALWAYS UNPLUG THE TOOL FROM THE ELECTRICAL RECEPTACLE
when making adjustments,
changing parts or performing any maintenance.
13.
KEEP PROTECTIVE GUARDS IN PLACE AND IN WORKING ORDER.
14.
AVOID ACCIDENTAL STARTING.
Make sure that the power switch is in the “OFF” position before
plugging in the power cord to the electrical receptacle.
15.
REMOVE ALL MAINTENANCE TOOLS
from the immediate area prior to turning “ON” the Utility
Sharpener.
16.
USE ONLY RECOMMENDED ACCESSORIES.
Use of incorrect or improper accessories could cause se-
rious injury to the operator and cause damage to the tool. If in doubt, check the instruction manual
that comes with that particular accessory.
17.
NEVER LEAVE A RUNNING TOOL UNATTENDED.
Turn the power switch to the “OFF” position.
DO
NOT
leave the tool until it has come to a complete stop.
18.
DO NOT STAND ON THE TOOL.
Serious injury could result if the tool tips over or you accidentally
contact the tool.
19.
DO NOT
store anything above or near the tool where anyone might try to stand on the tool to reach
it.
20.
MAINTAIN YOUR BALANCE. DO NOT
extend yourself over the tool. Wear oil resistant rubber soled
shoes. Keep floor clear of debris, grease and wax.
21.
MAINTAIN TOOLS WITH CARE.
Always keep tools clean and in good working order. Keep all blades
and tool bits sharp.
22.
EACH AND EVERY TIME, CHECK FOR DAMAGED PARTS PRIOR TO USING THE TOOL.
Carefully check
all guards to see that they operate properly, are not damaged, and perform their intended func-
tions. Check for alignment, binding or breaking of moving parts. A guard or other part that is dam-
aged should be immediately repaired or replaced.
23.
CHILDPROOF THE WORKSHOP AREA
by removing switch keys, unplugging tools from the electrical
receptacles, and using padlocks.
24.
DO NOT OPERATE TOOL IF UNDER THE INFLUENCE OF DRUGS OR ALCOHOL.
25.
SECURE ALL WORK.
Use clamps or jigs to secure the workpiece. This is safer than attempting to
hold the workpiece with your hands.
Содержание CAT 139 4500
Страница 10: ...10 PARTS LIST UTILITY SHARPENER PARTS LIST ...
