10
Fault Finding
Tests must be completed by a qualified electrical engineer.
If in doubt contact Meech head office or your local distributor.
CAUTION:
Whilst no danger to personnel exists, it is essential than any high
voltage ionising equipment, (exception Meech Model 910 Water Resistant
Ionising Bars), makes no contact with water or water based fluids.
Should such an event occur, disconnect immediately and return equipment to the
manufacturer for water damage assessment. High voltage electrical equipment should
not make contact with water.
The Model 977v3 Power Supply and Ionising Bar form part of a system.
To verify where a fault may have occurred it is important to test each item of the
system individually. Should more than one ionising appliance be connected to the
power supply, these must be tested individually.
To check the Pulsed DC system follow the procedure detailed below:
1. Switch off the electrical supply to the system.
