Meec tools 731111, Руководство по эксплуатации

Страница: 14 / 15

EN
14
13. Nozzle
14. Connection pipe
15. Nozzle
FIG. 1
USE
• The pump is not self-priming. The
magnetic rotor in the pump housing
generates centrifugal force, which conveys
the water to the nozzle, where it is forced
out.
• The fountain pump may only be started in
accordance with the safety instructions. It
can be placed in water or used in
combination with a fountain or pond
ornament. Position the fountain pump on
a level surface, slightly higher than the
bottom of the pond. This ensures that the
fountain pump will not become clogged
by sediment from the bottom of the pond
too quickly. If necessary, the fountain
pump can also be used in a horizontal
position. However, the motor shaft must
always be horizontal to avoid excessive
wear. Regardless of which nozzle is to be
used, it must be positioned so that it
protrudes above the surface of the water.
• All electrical parts in the pump are coated
with synthetic resin to increase safety. For
design reasons, there is a cavity at the
very bottom of the pump housing, where
water accumulates during operation. This
is intentional and does not represent any
risk.
MAINTENANCE
NOTE:
Unplug the fountain pump prior to
undertaking service and maintenance.
Cleaning the filter
The fountain pump’s sponge filter should
only be cleaned when required, as cleaning
also eliminates necessary microorganisms.
However, the filter must be cleaned as soon
as the fountain pump’s effectiveness becomes
noticeably impaired, or when the dust filter is
no longer working satisfactorily.
1. Press in the filter housing’s sides and
remove it from the pump body.
2. Take the sponge filter out of the filter
housing and clean it with clean, cold
water.
WARNING!
Never use the fountain pump without the
sponge filter as this can damage the pump.
Cleaning mechanical parts
Only when visibly dirty:
1. Open the cover to the pump chamber (3)
by turning the bayonet coupling for the
pump housing (9) one quarter turn.
2. Carefully take the magnetic rotor (8)
off the shaft (7). It is necessary to pull
sufficiently firmly to overcome the
magnet’s force.
3. Do not use any tools to clean the pump’s
interior, simply rinse it out with warm
water.
4. Use a soft sponge to wash away any
residual dirt.