21
Unplug the power cord before making any adjustments, changing accessories or putting the power
tool away. These safety precautions reduce the risk of accidentally starting the power tool.
Store power tools out of the reach of children and other unauthorised persons when not in use.
Power tools are dangerous if used by inexperienced people.
Maintain the tool in good order. Keep cutting tools sharp and clean. Properly maintained cutting
tools with sharp cutting edges are less likely to jam and are easier to control.
Make sure that moving parts are properly adjusted and do not jam and that no parts are damaged.
Check for other factors that could affect the operation of the power tool. If the tool is damaged, it
must be repaired before being used again. Many accidents are caused by poorly maintained power
tools.
Only use accessories recommended by the manufacturer for the specific model. Accessories that
are suitable for one tool may pose a risk of injury if used with another tool.
Service
Service work should be carried out by qualified service personnel only. There is a risk of personal
injury if unqualified persons carry out service or maintenance on the tool.
Only use approved spare parts and accessories for servicing. Follow the instructions in the section
on maintenance in these Operating Instructions. The use of non-approved parts or failure to follow
maintenance instructions can result in electric shock or other injury.
Special safety instructions
Failure to follow all the instructions and safety instructions entails a risk of serious personal injury.
Hold the tool steady during use.
Never use the tool clamped in a vice or similar.
Always wait until the tool has stopped moving before you put it down.
Hold the power tool by the insulated grips when working in areas where the tool may come into
contact with concealed electrical cables or its own power cord. In the event of contact with a live
cable, the metal parts of the tool will also become conductive and the user will receive an electric
shock.
Hold the power cord away from the cutting area and make sure it cannot become caught in the
workpiece or the tool.
Do not use the tool if it has suffered a heavy blow, has been dropped or has been damaged in any
other way.
Any extension cord must be earthed and double insulated.
The edges of the workpiece and swarf from the workpiece are sharp. Wear protective gloves and
shoes with thick soles.
Do not place the tool on swarf and sharp edges
– risk of damage.
Do not leave the tool unattended when it is running. Only operate the tool while holding it.
Always maintain a firm footing and good balance. Ensure that nobody is below the location where
the tool is being used.
Do not touch the cutting edge or the workpiece during or immediately after use
– risk of burns.
Look out for hidden electric cables
– risk of electric shock.
Safety instructions for use
Lubricate all moving parts and allow the tool to operate without a load for 1 minute before you start
cutting.
The maximum cutting width is 40 mm.
Move the tool parallel with the material.
Secure the workpiece firmly. Move the tool forwards with the side cutting edges pressed against
the surface of the workpiece. Never press the tool hard. If the motor speed falls during work, do not
press as hard in order to avoid overload.
WARNING:
Improper use or failure to follow safety instructions in these Operating Instructions can result in serious
personal injury.
Содержание 029-062
Страница 25: ......
