EN
34
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
For working in wood and other soft materials.
With V-belt drive and four different speeds.
Connected with standard single phase wiring.
1. 4-prong drive centre
2. Tool rest
2.1 Screw for height adjustment
2.2 Base for tool rest
3. Bed with motor unit
3.2 Bed
4. Lock nut
5. Tailstock
6. Crank
7. Foot
8. Locking lever for tailstock
9. Locking lever for tool rest
10. Power switch ON
11. Power switch OFF
12. Hex key
13. Face plate
14. Lathe tool, chisel
15. Lathe tool, round
16. Spanner
17. Screws with clamping disc and washer
18. Hex screws with clamping disc, washer and
nut
19. Drive axle
20. Locking screw
21. Drive unit cap
22. Locking screw
23. Motor unit
24. Lever for motor unit
25. Drive pulley
26. V-belt
27. Interlock switch
FIG. 1-4
INSTALLATION
1. Put the tool rest (2) on the bed with the
motor unit (3.1).
2. Put the tailstock (5) on the bed with the
motor unit (3.1).
3. Pull up the tailstock (5) and tool rest (2)
to check that they are correctly aligned.
4. Fit the bed with together with motor unit
(3.1) and the bed (3.2) without motor
unit.
5. Fit the parts of the bed together with 3
screws with clamping discs and washers
(17).
NOTE:
If it is difficult to move the tool rest (2)
or tailstock (5), adjust the washer on the
underside with a spanner or ratchet handle
with 19 mm sleeve.
SETTING UP
1. Place the product on a stable surface.
2. Screw the product to the surface with
screws through the holes in the three feet
(7).
3. The supplied hex screws (18) can be used.
4. Put washers and clamping discs on the
hex screws (18). See figure
XX
.
5. Screw the product to the surface with hex
screws, washers, clamping discs and nuts
(18).
