Meec tools 015269, Руководство по эксплуатации

Страница: 26 / 28

EN
26
AFTER EACH USE
Clean the product.
External cleaning
Rinse with clean water. Remove stubborn stains
with a brush and detergent. Lower the product
into a container with clean water and run for a
short time to flush the inside of the product.
Cleaning the intake
Clear the inlet. Open the pressure tube
connection and remove any fibres that have
wound around the rotor shaft. Remove
stubborn stains with a brush and detergent.
NOTE:
Before using the product again, allow it to
stand in the water for a while to prevent any
deposits and residue from clogging it.
STORAGE
If there is a risk of frost, dismantle and clean
the product and its accessories and store in a
frost-free place.
IMPORTANT:
Risk of material damage. The product and its
accessories contain water, which means that
they can burst if the water freezes.
• The product can also be used suspended
from the line.
NOTE:
When used hanging on the line: Do not
run the product without the outlet tube
connected. Make sure the product does not
turn around its longitudinal axis.
USE
When the product is connected to the power
supply it starts and stops automatically with
the float switch.
FIG. 2
• The product starts when the level of the
water rises and the float switch lifts (1).
• The product switches off when the float
switch has sunk to the bottom (2).
• The level switch cord can move in the
clip (3). The different levels between
starting and stopping can be adjusted
as follows.
• Short cord: Start and stop levels close to
each other.
• Long cord: Start and stop levels well away
from each other.
IMPORTANT:
Risk of material damage. The float switch
must be able to move so that the product
cannot run dry.
MAINTENANCE
BEFORE USE
• Check the casing and cords for damage.
• Check the float switch for damage. Lift
and shake the float switch to check that
the metal balls move.