Meec tools 015269, Руководство по эксплуатации

Страница: 25 / 28

EN
25
return valve are recommended to prevent
return flow when the product is switched off.
• Screw the outlet tube on the outlet
connection.
• When using a hose, screw the hose
adapter on the outlet connection.
• Press the hose firmly on the hose adapter
and secure with a hose clip.
• The hose adapter can be cut as shown in
the figure. In which case the hose is
connected with a 1 1/4 inch (32 mm) cap
nut.
IMPORTANT:
Risk of material damage. Tighten the hose
adapter by hand during assembly.
The threads can be damaged if overtightened.
INSTALLATION
In order to work properly the product needs a
free space of at least 50 x 50 cm for the float
switch to move freely. The product can be used
submerged, down to the depth specified in the
technical data.
• Install the product so that the intake
openings cannot be blocked. Put it on a
level, stable surface, if necessary.
• Check that the product is stable.
IMPORTANT:
Risk of material damage. Do not lift the
product by the cord or the outlet tube, they
are not designed to support the weight of the
product.
• Lower the product at an angle into the
water so that no air remains underneath
– otherwise this prevents suction.
Once the product is submerged,
it can be straightened up.
• Place the product on the bottom of the
tank. Lower it down with a line fastened to
the handle.
• Fasten the end of the line securely to
lower the product.
DESCRIPTION
Pump for draining and pumping clean water
(max 5 mm particles). Connects to earthed
power point. Not suitable for continuous
operation. Minimum water level to start:
100 mm. Residual level 5 mm.
PRODUCT PARTS
1. Handle
2. Hose adapter for outlet connection
3. Tube bend
4. Suction inlet
5. Float switch
6. Power cord and plug
7. Clip for float switch
FIG. 1
INSTALLATION
INSTALLATION AND
COMMISSIONING
Fasten a suitable line to the handle before
using for the first time. The line is used to lower
the product down into the water and to carry it.
NOTE:
If the product is used hanging from the line,
the line must be checked at regular intervals
for wear and damage.
Connection of outlet tube
Temporary use
For temporary use you can use a water hose
with a diameter of 1 inch (25 mm) to 1 1/2
(38 mm) inches.
Permanent installation
For permanent installation a tube and non-