EN
40
ones with the same technical data in
accordance with these instructions.
• Keep the product clean. Clean the product
after use and before putting it away.
Proper maintenance and regular cleaning
are essential for the product to work
satisfactorily.
• Clean the ventilation openings (8) on the
product after use. Use a brush for parts
difficult to get at.
• The product can be cleaned with
compressed air (max 3 bar).
• Always check the product, the power cord
and plug for damage before use. Do not
use the product if it is damaged.
• Check for any damaged parts. Take the
product to an authorised service centre,
or other qualified personnel, to be
checked and repaired.
NOTE:
Do not use strong or abrasive chemicals.
Polishing bonnet
• Remove the bonnet (11) according to the
instructions above.
• Wash the bonnet by hand in warm (max
30°C) water, or if necessary with a mild
soapy solution. Rinse thoroughly with
clean water.
• Allow the bonnet to dry before using it
again or putting it away.
Power cord
A damaged cord or plug must be replaced
by an authorised service centre or qualified
person to ensure safe use.
TIPS
• If you are not used to polishing, test first
on a sample or allow an expert to do the
polishing.
• The supplied bonnet (11) is only intended
for fine polishing and high gloss polishing.
A special pad or bonnet for rubbing with a
coarse polish or for waxing can be bought
separately. Contact the retailer.
• Never hold the product still on the same
spot on the surface, the development of
heat can overheat the surface can cause
irreparable damage.
• Polish corners, edges and other places
where the bonnet has a limited contact
surface verry sparingly.
• Replace the bonnet if it begins to show
signs of loosening from the disc support
plate (10).
AFTER USE
1. Switch off the product, pull out the plug,
and allow it to cool.
2. Check, clean and store the product as
described in the following instructions.
MAINTENANCE
WARNING!
• Switch off the product, pull out the plug,
and allow the product to cool before
cleaning and/or maintenance.
• Do not carry out any maintenance or
adjustments other than as described in
these instructions. Repairs must only be
carried out by qualified personnel.
General cleaning
• Check the product and all the accessories
for wear or damage before and after use.
Replace any damaged parts with new
