Meec tools 011637, Руководство по эксплуатации

Страница: 35 / 36

EN
35
4. Turn the mode selector for drilling/
percussion drilling (8) back to .
FIG. 14
MAINTENANCE
WARNING!
Switch off the product, pull out the plug
and wait until all moving parts have
completely stopped before adjusting and/or
maintenance.
CHANGING/REFILLING GREASE
The product is completely airtight to prevent
grease leaking out or dust getting in. Fill up
with grease after 50 working hours, or when
the percussion force is reduced.
1. Open the lid (1) on the grease holder with
the supplied key (12).
2. Fill up with grease and replace the lid. Use
gearbox grease.
FIG. 15
REPLACING THE CARBON BRUSHES
The carbon brushes should be replaced by
an authorised service representative or other
qualified personnel.
REPLACING THE POWER CORD
A damaged cord or plug must be replaced
by an authorised service centre or qualified
person to ensure safe use.
CLEANING
WARNING!
Never immerse the product in water or any
other liquid.
drilled and press the power switch (2) to start
the product.
1. Press in the lock (9) and turn the mode
selector for drilling/chiselling (8) to
position so that it engages.
FIG. 7
2. Turn the mode selector for drilling/
percussion drilling (3) to position .
FIG. 8
Percussion drilling
1. Press in the lock (9) and turn the mode
selector for drilling/chiselling (8) to
position so that it engages.
FIG. 9
2. Turn the mode selector for drilling/
percussion drilling (3) to position .
FIG. 10
Chiselling
1. Press in the lock (9) and turn the mode
selector for drilling/chiselling (8) to
position so that it engages.
FIG. 11
2. Turn the mode selector for drilling/
percussion drilling (3) to position .
FIG. 12
Percussion function only
3. Press in the lock (9) and turn the mode
selector for drilling/chiselling (8) into
position so that it engages. Adjust the
chisel to the required position.
FIG. 13