Meec tools 011637, Руководство по эксплуатации

Страница: 34 / 36

EN
34
STARTING/STOPPING
Push in the switch (2) to start the product and
release the switch to stop.
FIG. 6
MODE SELECTION
WARNING!
Switch off the product and wait until all
moving parts have completely stopped before
changing the mode selector. Otherwise the
bit can rotate unintentionally and cause
personal injury and/or material damage.
IMPORTANT:
• Do not put the mode selector for
drilling/chiselling (8) in position and
the mode selector for drilling/percussion
drilling(3) in position at the same
time. The product will not work in this
way. Use the mode selectors (8) and (3)
to set the required mode (drilling,
percussion drilling or chiselling).
• Do not press the bit too hard against the
surface. Pressing harder will not speed
up the work, but will put more strain on
the bit and/or product and result in a
risk of personal injury.
• Larger drill diameters put more strain on
the arms of the user. Hold the product
firmly with both hands. Always maintain
a firm footing and good balance.
• Always use the support handle.
• Be careful when working standing up on
a ladder or other high workplace.
• Fix the workpiece, if possible.
Drilling
Choose a suitable bit for the job and fit it
according to the instructions. Centre the tip of
the drill at the point where the hole is to be
of serious personal injury. The support handle
(5) makes it easier to control the product when
working.
1. Put the support handle as far as it will go
on the product.
2. Adjusting the handle to the required
position for the work to be done.
3. Lock the support handle in the required
position.
FIG. 3
FITTING THE DUST COVER
Always use the dust cover when working with
the bit pointing up, to prevent dust from
getting into the chuck.
1. Fit the dust cover (13) firmly on the
product.
2. When using large diameter bits the dust
cover can be mounted on the bit.
FIG. 4
HOW TO USE
IMPORTANT:
The chuck is intended to be used with the
SDS+ system.
Check that the bit shank and bit holder are free
from dust, lubricate the shank a little, and put
it in the chuck. This will ensure that the chuck
and the product last longer.
1. Pull the chuck sleeve (7) back as far as
possible.
2. Press the bit in the holder and twist it as
far as it goes.
3. Release the chuck sleeve. The bit locks in
place automatically.
4. Pull on the bit to check that it is correctly
inserted.
FIG. 5