Meec tools 000-106, Инструкция по эксплуатации

Страница: 61 / 63

GB
61
3. In particular clean the air vents (6) after every use with a cloth and brush.
4. Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
Maintenance
Before and after each use, check the product and accessories (or attachments) for wear
and damage. Check for worn or damaged parts. Replace worn parts as necessary or
contact an authorised service centre for repair before using the product again. Observe the
technical requirements.
Power cord
If the supply cord of this power tool is damaged, it must be replaced by a specially
prepared cord available through the service organization.
Repair
This product does not contain any parts that can be repaired by the consumer. Contact an
authorised service centre or a similarly qualified person to have it checked and repaired.
11. Storage and transportation
Storage
1. Switch the product off and disconnect it from the power supply.
2. Clean the product as described above.
3. Store the product and its accessories in a dark, dry, frost-free, well-ventilated place.
4. Always store the product in a place that is inaccessible to children. The ideal storage
temperature is between 10 and 30°C.
5. We recommend using the original package for storage or covering the product with a
suitable cloth or enclosure to protect it against dust.
Transportation
1. Switch the product off and disconnect it from the power supply.
2. Always carry the product by its main handle (8) .
3. Protect the product from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
4. Secure the product to prevent it from slipping or falling over.
12. Troubleshooting
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can be solved
quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualified specialist if you
cannot solve the problem yourself!