Meec tools 000-106, Инструкция по эксплуатации

Страница: 55 / 63

GB
55
7. Setup
WARNING! The product must be fully assembled before operation!
Do not use a product that is only partly assembled or assembled with
damaged parts!
Do not connect the product to power supply before it is completely
assembled!
Auxiliary handle
Adjust the auxiliary handle (14) according to the desired
application. It improves the control when using the
product.
1. Turn the hand grip (14a) clockwise to loosen the
clamp.
2. Place the quick clamp (14b) on the collar (3) .
3. Adjust the auxiliary handle (14) to the desired
working position so that you can hold the product
safely during operation. Make sure a notch of the
auxiliary handle (14) is engaged with the tooth on
the collar (3) .
4. Turn the hand grip (14a) anticlockwise to tighten
the clamp (Fig. 1).
0
1
2
14b
14a
3
Fig. 1
WARNING! Never operate the product without the auxiliary handle to
avoid accidents and injury! Always ensure that the auxiliary handle is
attached and secured correctly before operation! The auxiliary handle
provides better control of the product in case of sudden jams during
use when considerable forces are released!
Depth stop
Limit the drilling depth with the depth stop (15) .
1. Insert the depth stop (15) through the hole as
indicated (Fig. 2, step 1). Make sure the rule
marking is visible.
2. Align the tip of the depth stop (15) with the drill tip.
Now pull the depth stop (15) back by the required
drilling depth.
3. Hold the depth stop (15) in position and turn the
locking knob (4) clockwise until the depth stop (15)
is properly fastened (Fig. 2, step 2).
0
1
2
2
2.
1.
15
4
Fig. 2
Inserting and replacing a drill bit
Different drill bits can be used with this product depending on the material being worked
with.