3. The connector tubes on the commode arms and the cross brace
have holes punched in them. Please make sure the holes line up.
4. Insert an e-clip into the hole in each of the cross brace ends.
Insert from top down (the armrest pad is the top). Push the
middle post through the hole until the outer plastic ring snaps
over the frame tube. (Fig 3)
7. Next attach one the legs to the armrest frame: depress the push
button on the leg of the armrest frame and slide the leg onto the
armrest frame. align the holes in the leg so that the push button
will pop through one of the holes in the leg. Repeat with remaining
three legs. Make sure all four extension legs are installed at the
same height. Also make sure the push buttons are fully protruded
before using. (Fig 5)
8. Stand the assembled commode frame upright. (Fig 6)
5. Take the armrest frame and holding it horizontal, insert the
small connector tubes into the upper end of the cross brace.
Align the holes.
6. Insert the e-clips in the same fashion as in Step 4 above
to fasten the armrest frame to the cross brace. (Fig 4)
Figure 3
Figure 4
Figure 6
Figure 5
4 MEDLINE
1-800-MEDLINE (633-5463) | medline.com 5
