4
5
Specifications:
Power Source:
AC 100 – 240V 50-60Hz 0.2A
Charger Output/Clipper Input:
DC 3.3V 100mA
Motor Voltage:
DC 2.4V
Mode of Operation:
Continuous Operation
Battery:
2x Ni-MH (AA 600mAh - 1.2 Vdc)
Product Life Use:
This device has been tested to confirm operational functionality for more
than 50,000 15-minute uses, or up to 5 years of expected unit use in the
field. Inspect for damage prior to use and discard/stop use if clipper not
functioning.
Environment:
Operation
Storage Transport
Temperature:
+0°C to +40°C
-10°C to +60°C
Humidity:
30% - 75% RH
10% - 100% RH
Pressure:
700hPa – 1060hPa
500hPa – 1060hPa
!
Caution- Read accompanying documentation
Double Insulated
Watertight equipment
Type B Applied Part
DYND70800/DYND70801/DYND70802 SURGICAL CLIPPER
WITH RESPECT TO ELECTRIC SHOCK, FIRE AND MECHANICAL
HAZARDS ONLY IN ACCORDANCE WITH ANSI/AAMI STD.
ES60601-1 AND CAN/CSA STD. C22.2 NO.60601-1
Notes:
• Charge at room temperature of +41°F (+5°C) to +95°F (+35°C).
• Avoid charge in direct sunlight or near radiating heat.
To remove blade:
Make sure the On/Off switch is in the off position. Position the clipper over
an appropriate waste receptacle with the metal part of the blade facing
downward and the back of the clipper facing up. Push the blade away
from the clipper to release the blade. When not in use, after cleaning
and drying, place clipper body in the charging adapter for charging and
safe storage. Contact your Medline Representative to order replacement
blades. The blades are intended for single patient use.
Item numbers:
DYND70880: Universal Blade, Single Use, 50/cs
UBLADEFL: Universal Blade, Flat Style, Single Use, 50/cs
DYND70885: Coarse Hair Blade, Single Use, 50/cs
CBLADEFL: Coarse Hair Blade, Flat Style, Single Use, 50/cs
DYND70890: Narrow Blade, Single Use, 50/cs
NBLADEFL: Narrow Blade, Flat Style, Single Use, 50/cs
CSBLADE: Close Shave Blade, Single Use, 50/cs
Wall Mount Instructions: (Optional)
To install optional wall mount:
1.
Select an appropriate location on the wall using the screws provided.
2.
Attach the detachable wall mount with screws making sure that the
arrow on the back (flush part) points up.
3.
Slide the charging adapter grooves downward into the wall mount
until it clicks. To remove the charging adapter from the wall mount,
disengage and slide the adapter upward.
Care and Cleaning of the Clipper Body:
Always unplug the charging adapter before cleaning. To remove loose hair
and other gross debris from clipper, place under running water or soak in a
water bath. Wipe the clipper with a damp cloth containing a non-corrosive
disinfectant, such as: Isopropyl alcohol, OPA (Ortho-phthaldehyde), 2%
glutaraldehyde or any other non-corrosive disinfectant wipe. Dry clipper
with a clean towel. Return clipper to either the charging adapter or to a
storage area.
