TREADMILLS MOD. 870A/870S/870C
Rev.1/01.07.2019
© Medisoft RAM Italia S.r.l.. All rights reserved.
29
WARNING!
In case that the end user is not able to adequately check the equipment by
following the procedures as described above, or in the event that the end
user does not wish to carry them out directly, it is possible to request
assistance from the distributor or from the Manufacturer (Medisoft RAM
Italia S.r.l.) who will promptly communicate the terms and conditions of
technical assistance. Whatever the end user chooses to do, the
maintenance steps as listed in the above table, must be performed in the
way and frequency described thereof.
Failure to comply with any of the checks listed above, exonerates the
Manufacturer from any responsibility whatsoever for any accident or
damage caused because of it (par. 1.4).
5.2.1.1
Check performance of red STOP switch
After switching on the equipment by positioning the main power s
witch to “I”,
start the movement of the belt at any speed. Then press just one red STOP
switch and check that after activating the STOP the belt stops and the display
on the control panel (if present) switches itself off.
Repeat the operation for the other red STOP switch as well.
5.2.1.2
General cleaning of equipment
It is good policy to keep the equipment clean by washing it with soap and water
or with mild detergents. Avoid harsh treatments or rough handling that could
scratch the surfaces. Take particular care when cleaning the control panel, if
present.
5.2.1.3
Cleaning of side footrest belt
These belts are used to rest the feet and therefore need particular attention
during cleaning, as to keep them always in working order. This can be
accomplished by following item 3 on the table above.
5.2.1.4
Cleaning of drive belt
Use a vacuum cleaner and with the aid of a soft brush, brush off any residue of
dirt and dust from the drive belt.
If the surface of the belt is particularly soiled, it can be washed using a mixture
of 50% water and 50% detergent (AR19 Chemsearch).
It is advisable to start the treadmill to make the belt move at 1 or 2 Km/h and
after dampening a soft cloth with a mild detergent, lay it on the end part of the
belt (in correspondence to the back rolls) and keep it pressed as to obtain a
self-cleaning action.
5.2.1.5
Checking the integrity of network cables
The visual examination of the conditions of the cables and of the plug should
verify that both the cable and the plug are in good conditions and working order
