TREADMILLS MOD. 870A/870S/870C
Rev.1/01.07.2019
© Medisoft RAM Italia S.r.l.. All rights reserved.
37
ANNEX B - RS232 Serial Port
The treadmill may be controlled by an external system or computer through an
RS232 serial port. Positioned on the back of the treadmill hood, there is a 9 pin
connector.
If necessary, you can request from Medisoft RAM Italia S.r.l. the technical sheet
concerning the serial interface configuration and the transmission protocols
including the commands and the replies to the commands.
To utilise the RS-232 Serial Port you must:
•
Connect the 9 pin serial cable to the 9 pin connector, situated on the rear of
the Control Panel (or on the rear of the treadmill hood in the M version);
•
Verify that the Control Panel Display (when present) is in "MAN" mode.
•
The treadmill is ready to receive data from the external system.
The connecting cable is provided by Medisoft RAM Italia S.r.l.
WARNING !
The connection cable must be inserted with both the devices in OFF state.
The treadmills of the 800 series must be connected to devices meeting the
EN 60950 standard only.
