Working with Memory Cards
89
Alternate method of installing Navigation Software (using a
memory card)
The software for your navigation system can be installed directly from a memory card.
The pre-installed software may have to be uninstalled beforehand (see special Clean Up
function, Page 73).
You will be requested to install the navigation software during the initial adjustment.
Please proceed as follows:
1.
Remove the memory card from the packaging carefully. Ensure the contacts are not
touched or soiled.
2.
Push the memory card into the corresponding slot until it engages.
3.
Click on
OK
, in order to install the application.
The main screen, through which you will now be able to carry out the navigation settings,
will appear after all data has been copied to your navigation system.
Transferring Installation Files and Map Material to the Internal
Memory
Note
The navigation system must be connected to a computer by means of
ActiveSync® for the transfer of the data.
Your device has an internal, permanent memory, which is located in the
\My Flash Disk
directory.
You will be able to make this directory, and others, visible with ActiveSync
®
, by means of
the
Search
option. Directories and files can be manipulated as in Windows Explorer.
The required directory must have been stored, in order to make the installation files and
the map material for the device available.
Deposit the
INSTALL
directory for the installation files at (\My Flash Disk\INSTALL). Deposit
the map material in the
MapRegions
directory (\My Flash Disk\MapRegions). Please pay
attention to the modes of lettering given above when naming the directories.
Pay attention to the fact that sufficient drive capacity must be available, if you have stored
additional data on your navigation device. Remove files not needed if sufficient drive ca-
pacity is not available.
