6.
If controller shows errors, the easiest way to solve the
problem is to reset it
. Disconnect the plug from the socket
first and then from the belt or hands wrap connection terminal.
When you disconnect the plug from the appliance, please always
do it carefully with two hands, holding the connector with one
hand while the other hand pulls the plug. Pull the plug out of the
connector on the device carefully as well.
Do not pull it by the
cable or the connection between the hot stone mat terminal
and the controller plug may become loose
. After this always first
reconnect the controller to the mat tightly and then plug it into
an electrical outlet again. Be sure that the socket has electrical
power, this can be tested by using any other electrical device.
Reconnection and reset are the most common ways to
eliminate errors and reload the controller.
But if reconnection or any other way of troubleshooting do not
improve the situation, it likely means that there is a problem with
the controller. If your controller was not accidentally damaged or
flooded we will replace it ASAP, fast and free.
For warranty service, please contact us at
7.
Do not worry if your mat or pad are not hot to touch
. All FIR
Amethyst mats do not work like conventional heating pads. Most of
the energy from the hot stone mat, pad, belt or wraps in the form
of Far Infrared Rays heat, is transferred by radiation, and not by
conduction (as is the case with standard heating pads, which are
hotter to the touch but do not heat the body much). If the hot stone
mat is left uncovered, it should be slightly warm on lower levels, warm
on medium levels and very warm on high levels – but the transferred
heating energy is actually much higher, and this warmth is far more
penetrating. So the hot stone pads of any size from the small belts or
wraps up to Single or Queen mats should be used on a much lower,
more prudent temperature than a standard electrical heating device –
and it demands extra care, especially for all night use.
8.
It usually takes around 30-60 minutes for the pad to
reach the maximum temperature if you put both a thick
protector and a thick blanket on top
. The heating stops and
resumes again when the pad cools down, to maintain the set
temperature. During this time, the gems become very warm
and emit radiant Far Infrared rays. For extra electrical safety
the heating wires are positioned a short distance from the belt’s
edges so that the end tubes with crystals are heated indirectly
by other stones (these stones may have a lower temperature).
The surface temperature of the bare pad under the blanket, or
under your body if you are on the mat or pad, becomes hot to
the touch, especially in those areas which are covered by film
or mesh.
At maximum heat level It will reach 140-150 °F on
the surface, if measured immediately after you stand up or
remove the thick blanket. But if you measure the bare belt
or hands wrap surface temperature in several minutes again
it will be much lower, around 110-130 °F
. If the pad with
crystals is uncovered, and room temperature is low or the air
flow is strong, it will cool down very quickly. This is normal –
when preheated, the crystals transfer most of the energy in the
form of Far Infrared Rays. Hot stones radiate heat very quickly.
If you keep your mat, belt, wraps or any other hot stone pad
open without the protector pad, blanket, or your body on it,
the heat is dissipated – and though the controller may continue
to show rather high temperature inside the heating elements,
the surface will be merely warm to touch even on highest level.
TIPS: TAKING CARE OF YOUR MAT
1. The mat should not be used outside if you are not sure about
weather.
Use it indoors on flat surface as massage table, bed,
sofa, mattress or floor
. It’s ok if the surface is not ideally hard
and flat as board.
2. On sunny day you can “clean” and recharge your mat, belt
or wrap crystals. if you are sure that the rains are far away,
leave the mat or pad on the sun with crystals side upward for
a while. Ancient practitioners believed that sun beams clean
Amethysts taking away negative information accumulated
while healing and renews the crystals powers. Modern science
says that it is the UV (ultraviolet) light part of sun spectrum
that kills microbes and disinfects crystals. But anyhow it is
worth doing at least several times a year. It is wonderful to see
how amethysts and other gems really absorb a lot of energy
from sunshine and become much hotter than on the max level
of electrical heating.
3.
Only the flexible MediCrystal® pads and blankets can be bent
to wrap your body or used on chair or recliner while heating.
Classic Mini Mat (20x32”) can also be bent up to some degree
to cover your body while heating. But special Chair Mat is a
preferable choice for sitting practices in your chair or on the sofa.
4. Sometimes controllers and even devices issues happen after
power spikes. When hurricanes or storms are approaching, if you
are not going to use your hot stone pad for a while, or if you are
leaving your home for a weekend or vacation it is better to unplug
it from the socket.
The best is to keep your pad unplugged
from the power socket always while it is not in use
.
5. No need to unplug the controller connector from the pad
connection terminal frequently.
If the controller always
remains connected to the pad it is OK as this only helps
prevent the connection from loosening
. Just remember to
verify the tightness of the connections from time to time,
especially if you sleep on your hot stone mat. If you have to
disconnect the plug of the controller from the pad’s connection
terminal always do this carefully and with both hands. Hold the
connector with one hand while pulling the plug carefully with
the other hand.
If pulled by the wire it can break, or the
connection may eventually become loose and the pad will
not work correctly
.
6. Please take care of your hot stone mat, pad, belt or wrap and
it will be your friend for a long time. It is great for meditation,
sleeping, and sessions, if laying calm on it without a lot of
movement. Never apply pressure or step on it. Dogs and
especially cats adore it and can use but this should be under your
supervision. Do not allow heavy dogs to play in the same room.
Children like to jump but it may be very harmful if they jump
on the pad. There are a lot of tiny electronic parts inside such
as bimetal switches, temperature sensors, etc. Occasional acute
pressure may damage them. In order not to damage the inner
sensors and heating system electronics
avoid impact, walking,
standing, training, doing any active exercise on the pad. Do
not allow any heavy or sharp objects to be put on or fall on
it. Never fold it while hot, never heat it in folded condition
.
7. Most MediCrystal® mats come folded with the top surface with
crystals upside. But some models of MediCrystal® mats come
folded with crystals inward. Please, always fold the mat for
storage, same as it was folded when you received it.
If the mat
is folded in the wrong direction, it may be damaged. Do not
fold it too tightly and never put heavy objects on it
.
8.
Do not store the mat vertically along the wall
. Store the
device in the bag provided. Consider storing the controller and
plug separately so that the sharp edge of the power socket plug
does not damage the mat’s soft leather or suede. Do not store
the device in a humid, dusty or oily place. Store it in a clean
ventilated storage room or closet.
®
USER GUIDE
10
Содержание Classic Amethyst Queen Mat
Страница 1: ......
