Enigma Energi Owners Handbook
Page 12 of 22
Part Code: Z20942
ASSEMBLY, DISASSEMBLY AND TRANSPORTATION
ASSEMBLING POWERCHAIR
FOR OPERATION
•
Unfold the powerchair and lock the
frame in position by pushing down
on the sides of the seat with the
palms of your hand.
•
Place the battery tray into position,
ensuring the tray locks in to place.
Pull out the tray by pulling the
fabric handle on the rear of the tray.
•
Insert the batteries and then connect
the batteries together (Please see the
section on BATTERY CHARGING
AND CARE). Slide forward the
tray back underneath the seat
canvas
•
Connect the controller to the
batteries and check that the
controller is connected to the
motors (Please see the section on
BATTERY CHARGING AND
CARE)
•
Fold out the footrests until they are
locked in place.
•
Pull up both push handles and
ensure that the half fold back
mechanism locks securely (if half
fold back mechanism is fitted).
•
Make sure that the motors are
placed in gear
•
Make sure that there is sufficient
power in the batteries
DISASSEMBLING THE
POWERCHAIR TO TRANSPORT
•
Switch off the powerchair.
•
Fold and remove the footrests by
turning them backwards whilst
pushing the lever at the same time
•
Disconnect and remove the
batteries
•
Slide out the battery tray then lift
up to remove. Lift up the 4
brackets which the tray sits on.
•
Fold the back posts using the half
fold back mechanisms (if fitted).
To use the half fold mechanism,
push the plastic lever and pull the
push handles down and towards
you.
•
Unlock the sides of the seat by
lifting the seat canvas centre
holding both the front and rear
edges of the canvas
•
Fold the chair and transport
Under no circumstances should the
wheelchair be used as a seat in a
motor vehicle. The wheelchair user
should transfer to a normal vehicle
seat and the wheelchair should be
safely stored away. The wheelchair
has not been designed to be used as
a seat in a motor vehicle, and failure
to follow the above instructions
could result in injury.
