MediaKind RX8000
www.mediakind.com
5
3
Tuning the RX8200
The RX8200 should be set-up for over air control by Fox at first unboxing using its front panel. To
do this, the unit must first be tuned to a Fox over-air service. The tuning menus are accessed by
selecting root menu 3 (the
input menu
). To navigate to this page, press the
(Down) key on
the front panel three times (this will take you to the input status menu).
3.1
Input Configure
To access this function, use the
(Forward) key. This menu provides the ability to select both
the current Transport Stream and Primary Inputs.
INPUT
|SELECT INPUT SAT
3.1
|PRIMARY INPUT SAT
Use the
(Forward) and
(Back) keys to move between select input and primary input then use
then after selecting
EDIT
key use
(Up)
(Down) keys to select the required value from the
available options.
This shall be set to SAT for both SELECT INPUT and PRIMARY INPUT.
Once the selection is made press the
SAVE
key.
Next navigate to menu page 3.3.2 using the
(Down) and
(Forward) keys.
3.2
Source 1 Configure
This menu provides sub-menus that enable viewing and configuration of various Source 1 Input 1
parameters.
SOURCE 1
|CONFIGURE Input 1 (L-band)
3.3.2
|(UNLOCKED)
>
3.3
LNB LO Frequency
This field should be entered (in MHz, in steps of 1 kHz) with the frequency of the LNB (low noise
block down-converter) used with the satellite dish.
This shall be set to 05150.00
(this is the
local oscillator frequency for North American C-band LNBs)
To access this menu from the above menu, press the
(Forward) key.
SOURCE 1
|LNB LO FREQUENCY
3.3.2.1
|05150.000 MHz
(UNLOCKED)
Press
EDIT
then use the
(Up),
(Down),
(Forward) and
(Back) keys to enter the
frequency. Once the selection is made press the
SAVE
key
3.4
Satellite Frequency
This field should be entered (in MHz, in steps of 1 kHz) with the wanted satellite downlink
frequency. This will normally be within the C-band or KU band frequency range (in this case C
band).
For the Fox transponder G15 Vertical
this shall be set to 03820.00.
Once the
selection is made press the
SAVE
key.
To access this menu from the above menu, press the
(Down) key.