Media5 Mediatrix C710, Руководство по установке оборудования

Страница: 31 / 52

RESET/DEFAULT Button Hardware Installation Guide
Mediatrix C7 Series – Digital Gateway 19
At Start-Time
You can use the RESET/DEFAULT button at start-time – you power the unit off, and then depress the button
until the LEDs stop blinking and remain ON. This applies the “Factory Reset” procedure (see “Factory Reset”
on page 19 ). This feature reverts the Mediatrix C7 Series back to its default factory settings.
Partial Reset
The Partial reset provides a way to contact the Mediatrix C7 Series in a known and static state while keeping
most of the configuration unchanged.
Following a partial reset, the Mediatrix C7 Series management interface is set to the
Rescue interface. The
default address for this interface is 192.168.0.1/24 and has its corresponding link-local IPv6 available and
printed on the sticker under the Mediatrix C7 Series. Any existing network interface that conflicts with the
Rescue interface address is disabled.
You can contact the Mediatrix C7 Series at this address to access its configuration parameters. It is not
advised to access the unit on a regular basis through the
Rescue network interface. You should reconfigure
the unit’s network interfaces as soon as possible in order to access it through another interface. See “After a
Partial Reset” on page 19 for more details.
In a partial reset, the following services and parameters are also affected:

AAA service: User(s) from profile are restored with their factory password.

SNMP service: Resets the enableSnmpV1 , enableSnmpV2 , enableSnmpV3 and snmpPort
values to their default values.

WEB service: Resets the serverPort to its default value.

To trigger the Partial Reset:
1. Insert a small, unbent paper clip into the RESET/DEFAULT hole located at the rear of the Mediatrix
C7 Series. While pressing the RESET/DEFAULT button, restart the unit.
Do not depress before all the LEDs start blinking (between 7-11 seconds).
2. Release the paper clip.
After a Partial Reset
Following a partial reset, you should:
1. Create or activate network interfaces as described in the Software Configuration Guide , Chapter
Interface Parameters , Section Interfaces Configuration . Do not disable the Rescue interface!
2. Change the Mediatrix C7 Series system management network interface to something other than
Rescue as described in the
Software Configuration Guide , Chapter Miscellaneous – Management
Interface , Section Management Interface Configuration .
Note that you must be able to contact the interface you select in order to continue with the following
steps.
3. Contact the Mediatrix C7 Series through the new system management network interface.
4. Disable the Rescue network interface as described in the Software Configuration Guide , Chapter
Interface Parameters , Section Interfaces Configuration .
Factory Reset
The Factory reset reverts the Mediatrix C7 Series back to its default factory settings. It deletes the persistent
MIB values of the unit, including:

The firmware pack download configuration files.

The SNMP configuration, including the SNMPv3 passwords and users.

The PPPoE configuration, including the PPP user names and passwords.
The Factory reset creates a new configuration file with the default factory values. It should be performed with
the Mediatrix C7 Series connected to a network with access to a DHCP server. If the unit cannot find a DHCP
server, it sends requests indefinitely.