Media5 Mediatrix C710, Руководство по установке оборудования

Страница: 28 / 52

Chapter 3 - Powering on the Mediatrix C7 Series Indicators (LEDs)
16 Mediatrix C7 Series – Digital Gateway
Verifying the Installation
There are a few ways to verify that the Mediatrix C7 Series is properly connected to the IP network and is
working:

By contacting it with a SNMP browser

By contacting it via the CLI

By contacting it via a web browser

By pinging it
These procedures assume that you know the IP address of the Mediatrix C7 Series you want to verify. If the
Mediatrix C7 Series does not respond, do the following:

Verify that the LAN and WAN cables are securely connected to the Mediatrix C7 Series and to
the network connectors.

Be sure that you did not connect crossover network cables.

Verify the state of the IP network to ensure it is not down (the ETH1 or ETH2 LED should be
ON or blinking).
Indicators (LEDs)
The indicators (LEDs) of the Mediatrix C7 Series are described in “Mediatrix C7 Series Connectors and
Indicators” on page 1 .
LED Patterns – Specific Conditions
Table 6 describes the different states a Mediatrix unit can have and their associated LED patterns.
*#*1 MAC address of the Mediatrix C7 Series.
Table 5: Vocal Unit Information (Continued)
Digits to Dial Information Vocally Sent by the Mediatrix C7 Series
Table 6: LED Patterns
Condition Description LED Pattern
RestartPending Triggered when the RESET/DEFAULT button is
pressed in the ResetPending state. The unit
prepares for a physical shutdown and restart.
Power LED:
• blinking, 1Hz, 50%
duty
All other LEDs:
• OFF
RecoveryPending Triggered when the RESET/DEFAULT button is
pressed at start-time or for at least 7 seconds.
All LEDs:
• blinking, 1Hz, 50%
duty
DefaultSettingsPending Triggered when the RESET/DEFAULT button is
not released while in ResetPending state.
At run time, if the RESET/DEFAULT button is
released within 5 seconds, the unit applies
default settings, otherwise the action is
cancelled and the unit goes back to the
operation mode state or it resets.
At start time, the unit stays in this state until the
RESET/DEFAULT button is released. The unit
then applies the default settings and restarts.
All LEDs:
• steady ON