Media Pointe DMR300, Руководство пользователя

Страница: 13 / 45

DMR200 User’s Guide V1.1
13
Record Start / Stop Push Button
When pressed, the BLUE Start / Stop button will immediately begin (and subsequently
stop) recording and streaming (if defined in the setup) of the desired data. Pushing this
button has the same effect as pushing the “Record” button on the main menu page of
the unit. (See “Starting / Joining a Session” in this User Guide for more information)
The BLUE LED also functions as an indicator of the status of the unit. See Appendix A
for an explanation of the various states of the indicator. In general, the LED is ON when
the unit is ready to record, blinking when the unit is recording and OFF when the unit is
not ready.
Yellow LED Indicator
The Yellow LED indicator is used to show that the system is busy or in an error
condition. During normal operation of recording and streaming, the LED will remain off.
After each session is archived, the archive file must be fully indexed by the hard drive.
The yellow LED will blink during the indexing procedure indicating that the unit is busy
and cannot archive or stream until the process is complete. Depending on the length of
the archived material, this could be from several seconds up to 30 minutes to complete
the indexing process. The LED also serves as an internal error indicator. In the unlikely
event that an error occurs, the LED will blink. See Appendix A for an explanation of
the various states of the indicator.
RESET Button
The RESET button is hidden behind a tiny hole in the front panel and requires activation
using a small device such as a pin. This is done to avoid inadvertent resetting of the
system. Pressing the reset button will reset ALL the settings on the DMR300 back to
the factory settings . This includes all IP settings and Passwords. For a complete list
of the factory settings, see Appendix B . This should only be done if the user has lost
communication with the unit and has lost records of the IP address information.
Power Switch
This switch powers the unit on and off. It is used in conjunction the with main power
switch on the rear of the unit. It is intentionally made small as the DMR300 us
expected to remain ON most of the time.