medi protect.Ankle air foam, Инструкция по эксплуатации

Страница: 4 / 38

English
protect.Ankle air foam
Intended purpose
protect.Ankle air foam is an ankle joint brace. The product is exclusively to
be used for the orthotic fitting of the ankle joint and only on unbroken
skin.
Indications
• Conservative and postoperative care of ligamentous injuries of the
talocrural joint (degree II to III)
• After sprains
•
For chronic instability of the talocrural joint
Contraindications
None known at present.
Fitting instructions
• Open all the Velcro straps and fasteners.
• Adjust the heel width. Position the heel rest with the Velcro strap so that
the side pieces fit flush to the ankle.
• Hold the injured joint at 90°. Put the brace on so that the heel is in the
centre of the heel rest and the side pieces are flush with the ankle.
•
Now fasten the lower Velcro fastener. Make sure that the side pieces
remain parallel.
• Close the upper Velcro fastener.
• Pull one or both straps tight alternately until the brace fits firmly. Make
sure it does not press too tightly on the ankle joint.
Care instructions
Velcro fasteners should be closed for washing. Soap residues, lotions and
ointments can cause skin irritation and material wear.
• Wash the product by hand, preferably using medi clean washing agent.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
    
Storage instructions
Keep the product in a cool, dry place and do not expose to direct sunlight.
Material composition
Polyurethane, Polyester
Warranty / contractual guarantee
Consistent with legal guidelines
Disposal
The product can be disposed of in the domestic waste.
AAL_protect_ankle_Air_foam.indd 4 23.04.15 10:13