7
EN
5.1 Light unit
The BiliBed is equipped with a power cord attached to a 12V DC
power adapter. It is connected to the light unit. In order to remove,
pull on the plug housing (not the cord itself or the anti-bend
protection). Next to the power adapater, the START/STOP switch
can be plugged in to the socket in order to switch fluorescent
tube on and off.
Note
The electronics of the BiliBed are protected against damage
through voltage spikes in the mains electricity supply. If there
is an excessive voltage surge in the power network, your
BiliBed will switch off automatically. It can be turned on again
for further use by pressing the START/STOP switch.
5.2 Baby support
Preparation of the frame:
• Press the two red buttons underneath the frame at the
same time and raise the side of the frame.
Fitting the plastic cover to the aluminum frame:
• Unpack and unroll the clear plastic cover. There is a
groove on each of the long sides of the aluminum frame.
Insert the long sides of the plastic into these grooves.
Insert enough plastic to evenly cover the aluminum frame.
Close the frame by pressing the open side down with both
hands until it clicks shut. The plastic is now correctly
tightened.
The baby support can carry the weight of approx. 10 kg.
0
1) Head of BiliBed
0
2) Hour meters
0
3) Start/Stop switch
0
4) 12V DC power adapter
0
5) Socket
0
6) Foot end of BiliBed
0
7) Plastic cover
0
8) Button
0
9) Groove
10) Aluminum frame
1
2
3
4
5
6
7
8
9
10
8
9
Assembly
V
Содержание BiliBed
Страница 2: ......
