background image

12/03

© MEDC 2002

3.1 RECORDING

Regardless of input type, maximum duration of message cannot exceed 20
seconds.

INTEGRAL MICROPHONE INPUT

Ensure switch number one and two of SW1 are both in the OFF position.

Press and hold the Red record button, and speak into the microphone. Release
the button when you have finished talking.

To re-record the message, press and hold the Red record button, and speak into
the microphone as before. The previous message will be recorded over.

AUDIO SOURCE INPUT

To record from an audio source, set switch number two of SW1 to the ON
position. Connect the audio input CONN1 to the audio source via a mono
3.5mm jack connector. While playing back the audio source press and hold the
Red record button for the duration of the audio source. When you have finished
recording, remove the audio input and set switch number two of SW1 back to the
OFF position.

To re-record the message, press and hold the Red record button and playback the
audio source as before. The previous message will be recorded over.

3.2 NORMAL PLAYBACK

Ensure switch one of SW1 is set to the OFF position. Press the Green playback
button once to playback the entire recorded message.

3.3 REPEATED PLAYBACK

Set the repeat delay preset to 0s. Set switch number one of SW1 to the ON
position, and you will hear your recording repeat over and over. Adjust the
preset to increase the delay of the repeat to the required position. Note: In the
maximum position the repeat should occur approximately every 15 seconds.

To enable the unit to automatically go into the repeated playback mode, leave
switch number one of SW1 in the ON position when the unit is turned OFF.
When the supply to the unit is switched back ON the message will automatically
repeat at the set delay time.

Note: The message will not play straight away on power up, there will be a delay
depending on the preset value.

Содержание DB3V









Отзывы: