Inputs/outputs modules: MPNE
Mect Srl
23
ME7087_13 04/21
The parity
programming
is done by setting:
Dip settings
configuration
S-7
S-8
0
1
No parity
1
1
Even parity
1
0
Odd parity
To save the configured value, bits S1 and S2 must be set to OFF.
As long as dips 3 to 8 are at 0, the LED RUN and LINK indicate the current parity
configuration according to the following table, shown as below for the first 5
seconds.
Configuration
LED
RUN
LINK
No parity
OFF
ON
Even parity
ON
OFF
Odd parity
ON
ON
Stop bit: S1=1; S2=0
Procedure:
- Set all dip switches to 0 except dip 1;
- Power up the instrument;
- Wait a few seconds until the LED LINK flashes;
- Carry out the desired
programming
(see below);
- Set dip 1 to 0 and wait for the LED RUN to light up;
- Switch off the instrument;
- Set the Baud rate and the desired address;
- Power up the instrument.
The stop
programming
is done by setting:
Dip settings
Configuration
S-7
S-8
0
1
1 stop bit
1
0
2 stop bit
To save the configured value, bits S1 and S2 must be set to OFF.
