21
11
、
TROUBLESHOOTING
If you have any problem in installing or using the machine, we recommend
that you first check the following table for possible cause of the problem
and solution before asking for technical support.
MONITOR
Clean the monitor with water and soft paper.
PCB
Sweep the dust and dirty in the board with small
brush
PROBLEM
CAUSES
SOLUTIONS
no sample coin
insert sample coin
Sensitivity for coin was
adjusted too high
adjust the sensitivity
coin mech is bad
replace the coin mech
The wire of light is loose.
Check the connection of light board.
The light is bad.
Replace the light.
The light's driver board is ba
Repair or replace the driver board.
The connection of wire is
bad.
Properly reconnect the wires of motor.
The inverter is bad
Repair or replace the inverter
The motor capacitor is bad
Replace the motor capacitor
Motor is bad
Replace the AC motor
direction encoder circuit is
bad
connect the encoder circuit
direction encoder is bad
replace the direction encoder
the monitor power line is
loose
reconnect the monitor power line
Monitor signal cable was
not connected
reconnect the monitor signal cable
the mointor is bad
replace the monitor
The main board is bad.
Replace the main board.
The speaker is bad.
Check and replace the speaker.
The wire of sound signal is
loose.
Check the connection of sound signal.
The volume is too low.
Adjust the resistor VR1102 on main board to
increase the volume.
Have no
display.
Steering
wheel failure
Lights do not
light up
Have no
movement
Can not insert
coin
Have no
sound
Содержание Kiddie Pirate
Страница 26: ...26 12 5 Chassis 21 20 19 01 02 03 04 05 06 07 08 09 10 11 12 15 17 16 18...
Страница 29: ...29...