MechRC Shadow Stalker, Руководство пользователя

Страница: 16 / 27

turning on the robot & handset
pre-flight check
Each time you power up the robot, please review the six-point
check printed in the panel to the side of this page before
commencing operation.
S w i t c h o n t h e
handset by moving
the power switch on
the underside of the
handset to the "ON"
position.
1
W h e n p o w e r e d
up, the red light
o n t h e h a n d s e t
will be illuminated
constantly.
2
Switch on the robot
b y m o v i n g t h e
power switch on the
robot's backpack to
the "I" position.
3
T h e r o b o t ' s e y e
light will flash for a
moment and then
remain constantly
illuminated. It's
j o i n t s w i l l t h e n
move to their home
positions (shown on
the facing page).
4
Warning!
Whilst it is recommended
that you hold onto the robot
during the power up se-
quence to avoid it falling over
and causing damage to itself,
pay careful attention for sud-
den movements of the joints
which could cause fingers to
be trapped or crushed.
The safest place to hold the
robot during power up is on
the side of the body below the
chest (indicated by the arrows
on the illustration on the fac-
ing page).
For further safety instructions
on operating the robot, please
refer to the guidelines printed
at the front of this guide.
The robot is standing
upright in the “home”
position shown in the
illustration.
The eye light is illumi-
nated solidly
All cables are able to
move freely and are not
hooked up on the frame
of the robot
All decorative plastic
parts are firmly at -
tached
The robot’s servos are
not making any exces-
sive noise
None of the joints are
limp
Low Battery Warning
When the robot's battery charge
becomes too low for the robot
to function at full capacity, it will
cease all movement and output
activity (including audio) and will
flash its eye light constantly.