MechRC Shadow Stalker, Руководство пользователя

Страница: 15 / 27

preparing the handset for use
changing the infrared channel
U s i n g a s m a l l t o
m e d i u m s i z e d
screwdriver, undo the
screws holding the two
battery covers in place
on the underside of
the remote control
handset.
1
Insert batteries into the
battery compartments,
p a y i n g s p e c i a l
attention to the polarity
shown on the diagram
l o c a te d i n s i d e t h e
compartment. Replace
t h e b a t te r y c ove r s
and tighten the fixing
screws.
2
The channel setting
f o r t h e r e m o t e
c o n t r o l c a n b e
changed between
Channels 1 and 2
with the selector
switch located on
the underside of the
handset.
3
Warning!
Please pay careful attention
to the battery warning notices
printed at the start of this
guide. Incorrect installation of
batteries could cause perma-
nent damage to the remote
control handset and may re-
sult in fire.
The factory default channel setting for both the robot and the handset is Channel 1. If you need to change the channel on
which the robot operates (for example, if you are using two robots at the same time) then you can do so by following these
simple instructions.
Set the channel selector switch to
the desired position according to the
image shown here. You may find this
is made easier by using the nib of a
ball point pen.
2
1