DOC. MEUM-131205700. Version 01
5.
Power Switch
6.
Model No. of the Unit: PLA-600
7.
Display Light for Treatment Probe Connection. Green when connected and Red when not connected.
8
Display Light for Footswitch Connection. Green when connected and Red when not connected.
9.
ABLATION Display to show the preset ABLATION output value in tow digits.
10.
A Key used to adjust the ABLATION output value: Every time the key is pressed, the value will be
increased or reduced by one level. (Attention: Only after the output is closed, operator can press the keys
for change).
11
PLACOAG Display to show the preset ABLATION output value in tow digits.
12.
A Key used to adjust the PLACOAG output value: Every time the key is pressed, the value will be
increased or reduced by one level. (Attention: Only after the output is closed, operator can press the keys
for change).
13.
Display of time: After the device is started, it will show the work time
14.
Power Supply Display Light (Green): After power on, the light is green.
15.
Impedance Display: real time display of the impedance value when the unit is started up.
16.
The Unit Label
17.
Nameplate of the Unit: to show the unit general information, e.g. unit no., factory date, power, fuse
electricity, etc.
18.
Fan Inlet.
19.
Fuse.
20.
Socket of Power Supply Cable: the cable is of three-line, so the electrical outlet should also be of
three-line with ground lead.
21.
Knob for Adjusting Device Volume: volume gets bigger when it’s turned in clockwise rotation or
vice versa.
22
Socket for Flow Control Unit.
23
GND
3.3.3
Identification of Working and Warning
1.
Working: There is discontinuous single sound of one time per second; working light is on; and the
treatment function is started up with output.
2.
Warning: The warning light glitters. The detected impedance is over high.