NEED HELP? 1-800-832-2966
24
Spark Plug Maintenenace
1.
Remove the spark plug cable from the spark plug.
2.
Using the spark plug tool that came with the generator remove the spark plug.
3.
Inspect the plug electrode. It must be clean and unworn to produce a proper spark for ignition.
4.
Check the spark plug gap. It should be set according to Table 1
5.
After the plug is cleaned and gapped properly, reinsert back into the engine.
6.
Start threading the plug into the engine by hand to avoid cross threading.
7.
If the plug is new, it will need approximately ½ turn after seating to compress the washer. If re-installing the original plug, it will
typically require less.
8.
Re-attach the plug wire to the plug.
Torch Spark Plug Type
Spark Plug Gap
NGK Spark Plug Type
E7RTC
0.6-0.8mm
0.024-0.032in
BPR7HS
F7RTC
0.5-.07mm
0.020-0.028in
BPR6ES
F6RTC
0.78-0.94mm
0.031-0.037in
BRP6ES
Table 1
Air Filter Maintenance
1.
Remove the air filter by releasing the snap clips on
the top and bottom of the air cleaner housing
cover.
2.
Remove the foam element.
3.
Wash in liquid detergent and water.
4.
Squeeze dry thoroughly in a clean, absorbent
cloth.
5.
Saturate the filter element in clean engine oil.
6.
Squeeze out excess oil.
7.
Place the filter back into the air cleaner housing
and re-attach the air cleaner housing cover.
.
See Table 1
