NEED HELP? 1-800-832-2966
14
Handlebars (upper)
1) Hook the end of the clutch cable into the lever.
2) Route the cable into the cable bracket in the middle of the
upper handlebar assembly.
3) Slide the upper handlebar assembly down into the lower
handlebar assembly.
4) Align the bolt holes, and insert the saddle bolts and secure
with the handle knobs.
5) Ensure the cable is routed without being pinched or caught.
6) The cable can be secured to the handlebars using cable ties.
Tine Shields
1) Install the tine shields.
2) Place the outer tine shield underneath the main tine shield.
3) Secure each outer shield using the 6mm bolts, washers, and
nuts.
4) Securely fasten the center bolts first, then tighten the outer
two bolts on each side.
Depth Regulator
1) Tip the tiller forward.
2) Insert the depth regulator into the depth regulator bracket
between the wheels.
3) Insert the wire locking pin through the bracket and depth
regulator, ensuring the wire captures the end of the pin.
