Meccatronicore BB-Cure Midi, Руководство пользователя

Страница: 8 / 12

Special programs: Jewelry and Dental
These two dedicated programs have been
specifically designed for the finalization of
the special castable resins used in the
jewelry and dental.
The BB-Cure oven can be requested in the two
versions of Dental Jewerly both intended for
use with particular and specific resins used in
two different areas.
To start the program, just press the
corresponding symbols located on the lower
right.
Jewerly
Version
Dental Version
At this point a particular screen will appear where you can
select the necessary parameters:
- The duration of the program between 10 and 255 minutes
- The maximum temperature of the heating curve
including useful in the range between 40 ° and 60 ° C.
A right of the screen are two hotkeys:
Program annulment:
the program does not start
and returns to the stand-by page; (the adjusted data are
not saved).
Program start: It opens the screen with the state of
progress of the program; (The data is saved for later use).
The program status display will indicate:
- the selected program
- The total program time
- The set temperature
- the status of progress of the program.
The right screen will appear after you press the button:
(pause) the LEDs will turn off and the oven will wait for
further commands (in this situation you can open the lid)
Warning: Read the safety notes!
Once the lid closed, you can continue the previously
suspended the program by pressing the symbol:
The next screen shot will appear instead of pushing the
button: (stop) the LEDs will turn off, and then a confirmation
screen. (See figure here on the right).
You can then confirm the abandonment of the program by
selecting YES or return to the current program by pressing No.
Once the program is finished you will see a warning
screen will indicate that the successful outcome of the
drying procedure (see figure here on the right).
Premere ora il pulsante
to confirm.