Mec 3072ES, Руководство по обслуживанию и запасным частям

Страница: 22 / 254

October 2008 "3072ES / 3772ES / 3772ES HD" Service & Parts Manual
Page 1-6
Motor Section Disassembly
1. Make a “V” shaped set of alignment marks on the end-cover and housing to aid in the reas-
sembly process.
• Clamp the motor housing in a vise with the shaft facing down.
2. Remove the seven (7) bolts that hold the motor assembly together.
• Carefully remove the end-cover -
be aware that the piston and spring may fall out.
• Carefully remove the piston from the end-cover and set it aside.
• Remove and discard the O-ring seal and backup seal.
• Remove the spring and set it aside.
3. Lift commutator container and commutator from the motor and set aside.
• Place commutator on a flat, clean surface with the seal facing up.
• Gently tap on the seal with a small screwdriver until the opposite side of the seal lifts from
the groove. Remove the seal and discard.
4. Remove the manifold, rotor set, and divider plate. Remove all seals and discard.
CAUTION: Do not allow rollers to drop from the rotor assembly when removing the
rotor from the motor.
• Remove the drive link from the motor and set aside.
5. Clean all parts in an oil-based solvent and dry using compressed air. Apply a light coating of
fluid to all new seals prior to installation.
Motor Section Assembly
1. Install the drive link into the end of the shaft with the tapered end facing up.
• Place the rear housing seal in the groove in the housing.
• Place the divider plate onto the housing.
• Place body seals in grooves in both sides of the rotor.
• Place the rotor onto the housing with the side of the rotor with chamfer in splines facing the
housing.
• Place the manifold over the rotor with the seal-groove side up.
• Install the manifold seal
2. Install the commutator seal into the commutator with the metal side facing up.
• Use finger pressure to press the seal down flush with the surface of the commutator.
• Place the commutator onto the manifold and then place the commutator onto the protrud-
ing end of the drive link. Make sure that the seal side is facing up.
3. Install the remaining body seal in the groove on the end-cover.
• Install the piston spring into the end-cover, then the white backup seal followed by the
O-Ring seal.
• Line up the alignment pin with the hole in the end-cover and press the piston into the end-
cover.
• While holding the piston in place, lower the end-cover assembly onto the motor. Align the
“V” shaped marks that were made on the housing and end-cover before disassembly.
4. Install the seven (7) assembly bolts.
• Tighten bolts in sequence (see illustration)
• Pre-torque to 10 ft. lbs. (13.6 Nm).
• Final torque to 50 ft. lbs. (67.8 Nm).