Me CUVEO CR-UPS2000, Руководство пользователя

Страница: 17 / 44

EN
17
Delete all pre-configured
channels on the wireless
flush-mount switch
All preconfigured channels can be
deleted again.
a.) Plug the wireless flush-mount switch into
a standard 230 VAC mains voltage in the
manner indicated in the above section.
b.) Press button (2) until LED (1) flashes red.
c.) Before LED (1) stops flashing, again press
button (2) on the wireless flush-mount
switch. LED (1) will stop flashing, indicating
that the delete process has been
successfully completed.
FUNCTION TEST
Plug the wireless flush-mount switch into
a suitable 230 VAC mains voltage in the
manner indicated in the above section.
You can check the functioning of the
wireless flush-mount switch by briefly
pressing the corresponding “ON” button
of the relevant switch channel. LED (1)
will flash red. The switch contact at the
middle terminals is now activated and the
mains voltage is connected and an attached
device will thereby also be automatically
switched on. Briefly press the “OFF” button
of the corresponding switch channel on the
transmitter, which will prompt LED (1) to
stop flashing, the mains voltage at the centre
terminals and the device connected to it will
be switched off.
OPERATION
Connect a device to the switch contact.
Please read the chapter titled “Technical
Details” to learn more about the
maximum capacity of the device.
Operating the corresponding “ON” or
“OFF” button of the switch channel on the
wireless transmitter will cause the switch