9
- Slowly and carefully raise the loader and cycle the rollback/dump cylinders to
check hose clearances and to check for any interference.
- Operate the hydraulics on this product to check hose clearances and to check
for any interference.
- Make certain that the hoses cannot interfere with or actuate the quick-attach
mechanism.
- Make certain that hoses will not be pinched, or get tangled, in any equipment.
Do not lock the auxiliary hydraulics of your power unit in the “ON” position.
Refer to your power unit’s operator’s manual and this manual for procedures and
intervals, then inspect and maintain the entire hydraulic system to insure that the fluid
remains clean, that all devices function properly and that there are no fluid leaks.
WHEN MOUNTING THIS PRODUCT TO YOUR POWER UNIT:
Refer to the operator’s manuals of your power unit, your loader and your quick-attach for
special or detailed mounting instructions.
This product should fit onto the quick-attach or loader arms of your power unit the same
as the original products that were designed by your loader/quick-attach manufacturer.
If this product does not fit properly, contact your dealer or MDS Manufacturing Co., Inc.
before operating.
Never place your finger into the mounting plate or 3-point hitch or loader holes. A slight
movement of the power unit or this product could cause serious injury.
BEFORE EACH USE, THOROUGHLY INSPECT THIS PRODUCT AND:
Replace all damaged or excessively worn parts and hardware only with genuine MDS
Manufacturing Co., Inc. parts or with properly rated fasteners, hydraulic hoses or fittings.
Make certain that all locking pins, latches and connection devices are properly installed
and secured.
Make certain that all shields are in place and secure.
Remove all foreign objects from processor.
WHEN OPERATING THIS PRODUCT IN ACCORDANCE WITH DESIGN INTENTIONS:
Make sure bales are free from foreign objects.
Drive slowly through gates and doors.
Know you loader’s safe operating weight limit and the weight of your loader attachment.
WHEN ADJUSTING, SERVICING OR REPAIRING THIS PRODUCT:
Make no modifications to your processor.
When making repairs, use only genuine MDS Manufacturing Co., Inc. parts or, for
fasteners, hydraulic hoses or hydraulic fittings, use only properly rated parts.
Replacement parts, for parts with safety signs attached, must also have safety sign
attached.
THINK SAFETY!
WORK SAFELY!
