MDS 05-3624A01, Rev. B
OEM Series™ I/O Guide
5
1.4 Accessories
The transceiver can be used with one or more of the accessories listed in
. Contact the factory for ordering information.
Table 1. Optional Accessories
Accessory
Description
MDS P/N
Hand-Held Terminal
Kit (HHT)
Keypad terminal for programming,
diagnostics, and control. Includes
carrying case, cable set and an
instruction booklet. (Accessory Power
Adapter 03-3722A01 required for use
with OEM radios—see below).
02-1501A01
Accessory Power
Adapter
DB-25 male-to-female adapter that
attaches to the radio’s DATA
INTERFACE connector. Provides
regulated 10 Vdc for powering an HHT
or other low power accessory. If not
used, accessories could be damaged
by excessive voltage (equal to the
radio’s DC input voltage).
03-3722A01
RTU Simulator Assy.
Test unit that simulates data from a
remote terminal unit. Comes with
polling software that runs on a PC.
Used for testing OEM radio operation.
(NOTE: Older MDS RTU Simulators
will
not
work with the OEM radio as
they require a higher input voltage.)
03-2094A01
DB-9 to DB-25 adapter
Used to connect a PC with a 9-pin
serial port to the radio’s DATA
INTERFACE port.
01-3683A01
Radio Configuration
Software (EL705)
Radio programming software for use
with a Windows-based PC. This
program is available on 3.5” disks, and
is included on the MDS’ InSite 6.4 (or
higher) CD.
03-3649A01
PC Programming
Adapter Kit
Required when programming the radio
with a personal computer operating in
terminal mode. The adapter asserts
the auto-open signal (ground) on pin
23 of the DATA INTERFACE port. A
scratch-built cable may also be used
for this purpose (see
).
01-3683A01
