MDF Rose Engine Lathe 2.0
Build Instructions – Stepper Controls
56
Finishing It Up
Before screwing the bezel to the base, check to be sure
everything works. To do that, you will need to use the
instructions in the next section to load the programs into all the
pieces.
If it works, screw the two pieces together.
If you took the option to use the heat set inserts back on pg.
48, then attach the lid using four #4-40,
¾
” long screws (#403).
Otherwise, attach it using 4 thread-forming screws (#410).
When finished and powered on, it will look like the picture to
the right.
or
410
403
